Jump to content

Spiral chess set: Pawns + knight (in progress) 1.0

   (0 reviews)
Sign in to follow this  

3 Screenshots

About This File

I was looking for some nice test prints after getting my UMO+ up and running again, so I decided to m make the best of it and make my test prints into a nice chess set over time.

Printed so far:

 

  • Pawn 1: 0.20 layers, 200 degrees, 20 mm/s, 0.40 walls, 30% fill >> Overall a fine print, but an ugly overhang at the top edge
  • Pawn 1: 0.20 layers, 190 degrees, 20 mm/s, 0.40 walls, 20% fill >> Tried fixing the overhang by going colder, worked ok,-ish
  • Knight 1: 0.20 layers, 185 degrees, 20 mm/s, 0.60 walls, 15% fill >> Maybe too cold, overhang fine, but noticable lines on the surface

 




User Feedback

Recommended Comments

There are no comments to display.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!