Jump to content
Ultimaker Community of 3D Printing Experts

Leaderboard

Popular Content

Showing content with the highest reputation on 11/12/2017 in Posts

  1. Bonsoir @Dame_du_Lac C'est quasiment impossible a faire, tu trouveras peut être quelques idées sur le forum mais rien de bien efficace. Vu le peu de hauteur déjà imprimée sur ta pièce, je pense que ça ne vaut pas le coup de t’embêter avec ça et qu'il est préférable de relancer une nouvelle impression après avoir vu et corriger ce qui n'a pas bien fonctionné et bouché ta buse.
    1 point
  2. I just had the same issue. Because you mentioned about Cura 2.6.2, I was able to find a workaround for my problem. Hope this helps you as well, if you haven't already figured it out. This happens only for the 'custom printer' profile. If you select any of the existing machines included in the software, you won't get this error. I tried changing the 'machine settings' of my new custom machine, but no luck. But the custom machines which I had added a long time ago in the previous versions of Cura (which then were automatically migrated to the newer version when I installed one) were still wo
    1 point
  3. If you are on Cura 2.3 or later (that is when I started using Cura), go to the configure Cura under the 'Preferences' drop down. In settings uncheck the "Automatically drop models to the build plate." It may have been called something else in the past. But that will give you a lot of freedom to put in any value into the z field in the move type in box and it will hold that value.
    1 point
  4. ok ok ok, lets all take a breather and carry on as the decent people we are. Formally, I will inform you about the house rules, please keep them in mind while interacting with others on this forum I think it would be better to drop the subject about which is better, later or newer versions. It is up to everyone to decide. I think it goes without saying that there is a point in the rationale of deduction suggested by @cloakfiend, but how to execute it is for everyone to decide. (and have you really talked to flat-earthers or was this a metaphor? Must have been intriguing!) As for my 2 cen
    1 point
This leaderboard is set to Amsterdam/GMT+02:00
×
×
  • Create New...