Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 03/17/2019 in all areas

  1. 1 point
    Hi vwguy16, Just some more info; the two black wires is power for the heater, the two gray wires is going to the PT100 temperature sensor. Both, the heater and the temp sensor is not polarity sensitive, as they are floating from ground. When looking into the printer, the two connecting points to the left is for the heat bed and the two to the right is for the PT100 temperature sensor. Good luck Torgeir-
  2. 1 point
    FYI, I submitted a PR (https://github.com/Ultimaker/CuraEngine/pull/1014) to fix this, don't expect to see it in Cura anytime soon.
  3. 1 point
    Thank you for the reply. So I will not order it.
This leaderboard is set to Amsterdam/GMT+02:00
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!