Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 07/10/2019 in all areas

  1. 1 point
    Personally, I'd get the parts from UM or an authorized seller, eBay ones can be very hit or miss with poor QC and there's no real reason to equip a printer of this price range with crummy sub-par parts. UM will have done their due diligence on finding a reputable supplier of quality parts, there's no reason to try to reinvent the wheel for saving $20
  2. 1 point
    Damn, too slow again, but anyway: Well, 3d-printing depends on solid, "watertight" models. The model in your file is the exact opposite... 😛 It consists of 114 separate (mostly overlapping) shells with paper thin walls, it's not usable for any manufacturing method that i'm aware of. I'm not an expert and i don't know your modeling software, but there are tutorials for nearly everything out there nowadays... All i know is: you need to create a solid, watertight model without intersecting faces, without internal structures and so on.... And as a rule of thumb: walls should not be thinner that two times the nozzle diameter, if you want to print it later. Good luck!
  3. 1 point
    Thanks for the file @cerons. It only contains the model and not the settings (you need to do File -> Save to save the settings and the model). Anyway, the model has problems. The mesh tools say it's not watertight (bad news for a water slide!). To be printable, the model needs to be watertight.
  4. 1 point
    Hi marcottt no at the moment, I come back to one extruder because cyclops was a crazy of jams and I couldn`t setup well. Regards Gustavo https://www.thingiverse.com/danzig483/about
  5. 1 point
    @shambam I follow the standard maintenance and clenaing procedures set by UM for my UM3E, worked like a charm so far. https://ultimaker.com/en/resources/52604-clean-the-printer https://ultimaker.com/en/resources/52613-clean-the-feeders
  6. 1 point

    Version 1.0

    476 downloads

    PLA Faberdashery Buse 0.2
This leaderboard is set to Amsterdam/GMT+02:00
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!