Jump to content
Ultimaker Community of 3D Printing Experts

Leaderboard

Popular Content

Showing content with the highest reputation on 06/20/2020 in all areas

  1. In case you would find a way to install the "wrong" firmware (which is not so likely as Ultimaker certainly thought of users accidentally installing a wrong firmware) you probably would find the printer not working properly as the S3 has different electronics than the Ultimaker 3. In the worst case you might damage the printer. Does that answer your question?
    1 point
  2. When printing with wall line count at 3 I've had the infill kinda show through. Increasing the wall count usually gets rid of the marks. At a wall line count of 5 I rarely see it. I've never played with Infill Overlap Percentage but it sounds like the kind of setting that could have an effect on low line count walls and marring of the surface by the starts and stops of the nozzle when putting the infill in place.
    1 point
  3. Hey Hey Hey guys these are complicated solutions why dont u put a support at the starting of the conic model manually
    1 point
  4. Disabling "Remove Empty First Layers" allowed to slice in mid-air.
    1 point
This leaderboard is set to Amsterdam/GMT+02:00
×
×
  • Create New...