Jump to content
Ultimaker Community of 3D Printing Experts

Leaderboard

Popular Content

Showing content with the highest reputation on 09/12/2020 in all areas

  1. That looks like 7 seriously under-extruded walls and a seriously under-extruded infill. You said there were no outer skins...was there a gap between the brim and the parts? If the answer is "no" then there is the answer. The walls are there, they just under-extruded so badly that the gaps make then look like infill. You have printed the set of parts before and Smithy mentioned warping. Those curved tuning fork looking parts are prime candidates for warping so I will assume you have an enclosure. I will also assume that the extruder is within the enclosure. The high heat environment
    1 point
  2. Small python tool that helps adding 3rd party material to Ultimaker S5 on-display material type selection. https://github.com/flyinggorilla/ultimaker-s5 I do like the NFC enabled Ultimaker filaments and I am impressed how easy printing with the Ultimaker S5 can be. However, ordering filament through third party vendors is always a challenge, because they usually have only a fraction of filaments in their stores. Also do my use cases go beyond Ultimaker filament material types. So i complement Ultimaker material now primarily with FormFutura material (they have a great o
    1 point
This leaderboard is set to Amsterdam/GMT+01:00
×
×
  • Create New...