Jump to content
Ultimaker Community of 3D Printing Experts

Leaderboard

Popular Content

Showing content with the highest reputation on 06/04/2021 in all areas

  1. Pour éviter de te faire défonce par la patrouille aka : @darkdvd. Je te conseil de passer sur la version Cura 4.8 de Creality. Là tu auras la config de la Ender-6.
    1 point
  2. There have been a couple of people that have come in here with questions about setting up Cura for a paste extruding machine. If you do a search of the forum, those posts should come up. Maybe a PM would be in order to ask them a question directly. Personally I don't know anything about it. In regards to pellet extrusion, those are generally larger machines that put out a lot of material. As a retired old fart and hobbyist I have no need to FDM print a house or boat. Here is an example of one poster's pellet extruder in this thread. It's a self-built printer, it takes up a lot o
    1 point
  3. KB3126587 did not work for me (had error "The update is not applicable to your computer") so i tried KB2533623 solution. It turned out that KB2533623 is superseded with KB3063858 https://www.reddit.com/r/windows/comments/ik7sp7/does_anybody_have_the_kb2533623_update_for/ which worked for me.
    1 point
  4. Hi @Splatman this is depending on what g-code flavor your printer is using. So choosing the method is very firmware specific to your printer. And with the method BQ (M25) from the video there are more options.
    1 point
  5. Hello, At the Transformation Summit there was a plugin for Cura mentioned, that guides through the creation of a material profile called "Profile Assistant". Can I get that somewhere? I got a material but it really doesn't print well on my UMs with the default profile in Cura and I'm a little lost where to start. I looked basically everywhere and wasn't able to find it. When googling it, there seemed to be a support article but it says I'm not allowed to view it 🤔. When I get it to working fine, can I contribute the profile somehow into Cura or are only manufacturers al
    1 point
  6. Kleiner Tipp, verbau das Teil hier: https://www.thingiverse.com/thing:1546811 (Falls es beim Connect passt) Ich hab den Halter in Betrieb seit ich den UM2+ hab und es läuft und läuft und läuft 🙂
    1 point
  7. I haven't printed with ASA so I'm not sure if it gets any better than this. PLA is just such a wonderful material if you are looking for good looking prints. I've heard people call those "zits". I don't care about them much so I haven't paid too much attention but they happen when the pressure in the nozzle is high and some filament squirts out sideways in the cracks. I'd try cutting the speed by 2X to see what happens and play with it from there. I think you can do that live in the TUNE menu. Also in Cura make all your speed settings the same. By default Cura prin
    1 point
This leaderboard is set to Amsterdam/GMT+02:00
×
×
  • Create New...