Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation since 11/05/2019 in File Comments

  1. 1 point
    I have used this concept before when printing large overhangs. It was based on an idea of another user, but I forgot his name (might have been smartavionics?). It works very well, even with only a few connecting strands. My strands were 1mm long, 0.5mm wide, and 0.2mm high (=2 layers of 0.1mm). Inverted triangles to generate support do not work well for small layer-heights of 0.1mm: they tend to curl up too much. Inverted staircases (1mm steps) worked better for me. See the pics. So, depending on the design, this method can be very usefull. Inverted triangles curl up too much. Basic concept: Long bridge with hanging support, so the text below does not get damaged by the supports. All plates are 1mm thick in this test. The little ribs on top of the support are 0.5mm wide, separated 1mm. The result. The supports can easily be removed, and they do very little damage to the walls.
This leaderboard is set to Amsterdam/GMT+01:00
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!