Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation since 05/25/2019 in 3D Print

  1. 1 point

    Version 1.0

    498 downloads

    A test sculpt of my friends dog.... still trying to get my UM2 back to spec. Didnt realise the 35W heater needed a PID alteration or something, but hopefully I'll have that sorted and will be back to making near flawless prints. No closeups here because they are not worthy of closeups.
  2. 1 point

    Version 1.0

    1,069 downloads

    Hi ultimakers, Here is one of my projects which is made on Ultimaker3.
  3. 1 point

    Version 1.0

    1,475 downloads

    This model was tested in Cura 15.06. To avoid printing problems, we recommend the following settings: Quality Layer height: 0.1mm* Initial layer thickness: 0.3mm Bottom/top pattern: lines Skin perimeter line count: 0 Horizontal expansion: 0.04mm (when entering 0.04mm index, the 3D printer perceives the model as monolith, i.e. as having no hidden layers). *Layer Height 0.1mm is recommended for a better quality for the printed model. However, the printing time will double. Speed setups: Infill speed: 30mm/s Outer shell speed : 30mm/s Inner shell speed: 20mm/s Top/bottom speed: 20mm/s Support speed: 50mm/s Travel speed: 150mm/s Skirt speed: 30mm/s Amount of slower layers: 4 Infill: Infill pattern: Grid Line distance: 1.5mm Infill overlap: 20% Infill layers: 0 Support: Enable support: Check Placement: Everywhere Overhang angle: 30° X/Y distance: 0.7mm Top distance: 0.2mm Bottom distance: 0.2mm Stair step height: 0.5mm Join distance: 0.7mm Area smoothing: 0.6mm Use towers: check Pattern: Lines Line distance: 1.5mm Platform adhesion: Type: Brim Brim line count: 10 (up to 20, depending on the model’s height) Other 3D printing recommendations: Outer Shell Speed - 20mm/s and Support Speed - 40mm/s settings apply to avoid model deformation. Apply other settings by default. Disclaimer: This model will look outstanding if printed on SLA/SLS 3D printer. The accuracy of the model printed on FFF printer can vary from the result shown in the pictures.
This leaderboard is set to Amsterdam/GMT+02:00
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!