Jump to content

IRobertI

Moderator
  • Posts

    3,538
  • Joined

  • Last visited

  • Days Won

    39

Community Answers

  1. IRobertI's post in Share customizations between installations was marked as the answer   
    Click on Help->Show Configuration Folder and it'll open up the folder that holds the settings for your install.
  2. IRobertI's post in Installing Ultimaker S5 R2 Motherboard into an Ultimaker S3 was marked as the answer   
    The boards are the same, but they need to be "provisioned" so that they know which type of printer they are installed in. Instructions for that can be found here:
    https://support.makerbot.com/s/article/1667410987665
  3. IRobertI's post in Hotend not centered was marked as the answer   
    Your print head is mounted backwards. Remove it by unclipping the rods that go through the print head from the sliding blocks and rotate the head 180 degrees.
×
×
  • Create New...