Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Everything posted by gnafin

  1. I have to redo the thermocouple board plug. where can I get the white female plug?
  2. I got it to work. just cut the tab off of the one end of the plug. so you can plug it in 180 off. you want the red strip of the wires by the switch side.
  3. gnafin

    13.06.3 issue

    Hmm, it works for me...
  4. gnafin

    Looking for beta testers.

    I would like to test the new software as well.
  5. gnafin

    z-height adjustment

    Hi, on my thing-o-matic we set the z-axis by putting a card or paper under the nozle.. turn the ballscrew till the card is tight then hit ok. and this sets the z-axis start height.... now this is with rep_g but can we have something like this for Cura? be nice.
  6. gnafin

    what is this red thing

    what is this red part on screen
  7. i was going to replace my rods and bearings as they look bent... where car i get then here in the usa...
  8. on my Thing-o-matic i run a scrip to calibrate the center and the z height... could we do this on a Ult? is would be so ez to just z down get the height you want and save it...
  9. has anyone tried to use the makerbot thing o matic hotend on the ultimaker? i have never had a problem with my mk6.
  10. gnafin

    head temperature

    when i check the temperature of the head it does not match my temperature gage.... if i set a temp of 200 and i check it i just get 170... is thier a adjustment?

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!