Jump to content

hansjw

Dormant
  • Posts

    1
  • Joined

  • Last visited

    Never

hansjw's Achievements

0

Reputation

  1. I have this same problem. I have had my Ultimaker since last Fall. I have been printing with it for many months without (too many) problems. I just recently updated the firmware to the latest version (Marlin rc2 - ugraded from Marlin beta2), and now, the extruder gear won't turn anymore after the print starts. It spins like crazy during the pre-print extrusion, but once it starts printing, the gear doesn't move at all. I have turned up the speed and let it print for a while to see if it was just turning slowly, but it stays on the same tooth. I am using ReplicatorG 0035. It was printing fine just before I upgraded the firmware, so I know it is not a mechanical issue. Any help would be greatly appreciated. Thank you.
×
×
  • Create New...