Jump to content
Ultimaker Community of 3D Printing Experts

xye

Dormant
  • Content Count

    2
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. Hi Owen. Yes my Machine is set to Ultimaker Sprinter/Marlin. I looked at the Daid Marlin builder but there was so much I just didn't know what it did or how it should be set up.
  2. I just finished making my Reprap Prusa Mendel. It came supplied with an Arduino Mega and a RAMPS 1.4 board, I've loaded the Marlin firmware (ErikZalm-Marlin-538189c) to the Arduino, and loaded ReplicatorG Ultimaker Edition 0035 to my computer. I've not connected any of the stepper motors or thermistors to the board, and I've used the standard 4 pin molex power connector from a computer power supply ( the 12v to the 11A and the 5v to the 5A, I'm not sure about the 5V thing) My problem is when I try to connect to the board through RepG to the board but I get the error message: [18] Wrong baud
×
×
  • Create New...