adam

That does look alot better, I'd also suggest some clarity on what should be done for the steps per E test.

Sorry for the delay in replying. Last week I tried using Cura and couldn't get past the first run setup, took it over to a friend who is more electronically inclined than me and it worked, no change in what I was doing. I take it back to my house and it doesn't work, again, no change. I ignore it for a week and try again, and it works, no change in what I did. If it is a physical problem, my guess is something's wrong with one of the wires, or the USB cable. However, I'm betting it's just the software.

Correcting the end stops was the first thing I had to troubleshoot, they are properly aligned. I'm actually trying to figure out Cura now, if I can get that to work then I won't worry about ReplicatorG.

This is for my very first print, I have yet to print anything. After reading through the setup and newcomer guide, and trouble shooting a lot of things, I finally got the program and machine to work correctly, however once I click print for the .5mm wall all the machine does is lower the Z platform 35mm and extrude a string. I'm lost on what the problem is, I'm assuming it's somewhere in the skeinforge, any ideas?