Ok. But I often have several gcode files for the same model that I've renamed with their parameters. Is it possible to get just a simple load button, or that if you select a gcode from the main window that on load finish it pops you into the print window?
I totally agree, Daid's suggestion works in an engineering world, but is utterly not intuitive for the rest of humanity, especially if it is not explained anywhere.
a simple 'load gcode" button will fix this, now that Daid killed off print run from the package (which may not have been the wisest choice at this point of the development stage ).
This would be very helpful especially for Gcode of very complex models that cannot be sliced with CURA and are sliced by an other software like netfabb.
Fritz