diabolov

Ahh! OK sorted it. As default the screen opens divided into two with the divider just right of the last tab '' Start/End Gcode'' I didn't realise you could pull this across, as you do up pops a disable X.. Thanks Bobby for making me look closer. Regards Mark

Hi All, I'm running Cura on a windows machine and I recently started to play with plugins. My question is on the cura site under ''how to use plugins'' is says ''to disable the plugin click on the X'' and shows a Mac screen shot with a lovely big X button, Now! on my windows layout I don't have a lovely big X button to click on so how do I disable the plugin ? Regards Mark

Just a thought but are you using the ultimaker acrylic bed ? have you measured the thickness of the acrylic at each corner. I know from experience that acrylic sheet is never the same tolerance over its length/width. Also have you tried turning the acrylic bed around so front becomes back and does the problem now occur in the rear right corner? If you can eliminate some possibilities then you can narrow it down. Regards

Hi Bill, Try Dichloromethane (liquid solvent cement) it has a water like consistency. It's what I use as a professional model maker. Regards Mark

Glad you found a solution. D

Hi, I had the same problem ( not with Linux though), so i double checked the end stop connections and they where all ok.....just to eliminate any error as i had run out of options I swapped the right and left X end stop cables over on the motherboard underneath and it worked...as Diad says it had been lasered up wrong left was right and right was left. regards D