Jump to content

infinityvisions

Dormant
  • Posts

    3
  • Joined

  • Last visited

    Never

Everything posted by infinityvisions

  1. Problem solved by rearranging cables in the PCB, not over it but under and around it. Cura doesn't work in my Windows 7 32 bit machine. The printing windows with statistics doenst show up. But it does work in the Mac. So Now printing!!!
  2. The problem of the temperature check up was solved by re conducting the wires in the pcb (I guess). Some were on top of it.I do not know if they caused some kind o interference.
  3. I assembled the printer without any problems and it was a fun experience. When trying to download the software Replicator G. there is no link anymore to this software only to Cura 12.10. So we downloaded Cura in a W7 32 bit machine and run the Ultimaker Checkup multiple times getting an error "Temperature measurement failed" I installed also in a Mac and we got the same results. I looked in the forum and rechecked all the wire connections that were Ok, and also measured the two white heater wires and got 9.4 Omhs. Whys the Checkup is failing? Any advise? Thanks
×
×
  • Create New...