Jump to content
Ultimaker Community of 3D Printing Experts

mrszozd

Dormant
  • Content Count

    5
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. hello, I'm looking for some idea how to calibrate the printer to get directly the same dimensions like in the model. After several prints i recieved 6,93-6,94 [cm] and 7,05 [cm] from square designed at 7x7[cm] have You got idea how to calibrate this? I know that there are some calibration models and procedures available but the only problem that I see is that those models are tubes, spirals which are hard for precise measuring...
  2. could it be that I named the file with non-english letters?
  3. hello, I've downloaded the Cura for testing (mainly because retraction possibility). but I've got problem with slicing each model (apart of ultimaker robot). could You please check the log and give me some tips how to fix it. thanks 0.00: 0 Missing default setting for: 'extruder_offset_x0' 0.00: 0.0 Missing default setting for: 'extruder_offset_y0' 0.00: 0.0 0.03: File C:\Users\mrszozd\3D!\Cz???1.stl is being chain exported. 0.52: Carve procedure took 0 seconds (23271). 0.55: Preface procedure took 0 seconds (74478). 3.40: Inset procedure took 3 seconds (74696). 12.54: Fill procedu
  4. many thanks for response, I'm looking forward to test it
  5. hello, when I set the center print in the netfabb it's not really in the center of the printing table (it's more to the right side). Have You got idea how to fix it? Cause it stops me from using whole space in the table, which as You can imagine can give a lot of fun ;] btw: what is the latest firmware for the printer? I've got Marlin_v1, is this the newest one?
×
×
  • Create New...