Jump to content
Ultimaker Community of 3D Printing Experts

qwertyharry

Dormant
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Thanks for the replies guys. After quite a lot of trial and error, then trawling through marlin code, then more trial and error, it seems it was caused somehow by the fact that I had the "watch" box ticked in pronterface. I have always done this before without problem, but somehow with my new prefix gcode I get the bug described above, every time. Now that I am not "watching" with Pronterface, no problems.
  2. I'm reposting this as a topic in Marlin, now that I have realised how the ulticontroller interfaces with Marlin. I'm using Marlin configured to use a heated bed via Daid's Marlin builder in December 2012. I have been experimenting with print start gcode and put together the following to extrude a bucket of plastic in a nice fat line to ensure a properly primed print head. When I load this file into pronterface and hit print, it works as expected, but if I load it onto the SD card and print from there, it pauses midway and displays "Wait for user..." on the Ulticontroller LCD until I press t
  3. No, the problem is not related to Cura. The code above is pasted into notepad, saved as a .gcode, uploaded to the SD card in the Ulticontroller, then printed.
  4. I'm not exactly sure if this is a Marlin issue, or an Ulticontroller one. I'm using Marlin configured to use a heated bed, otherwise standard. I have been experimenting with print start gcode and put together the following to extrude a bucket of plastic in a nice fat line to ensure a properly primed print head. When I load this file into pronterface and hit print, it works as expected, but if I load it onto the SD card and print from there, it pauses midway and displays "Wait for User" on the Ulticontroller LCD until I press the button on the front, then it continues. The point at which i
  5. Huh! Thanks Daid. I guess I misinterpreted the little help notes. I read "3th heater output" (obviously on the ultimaker board) as "3rd Extruder.." (on the Builder form.) Cheers.
  6. Trying to build firmware at http://daid.eu/~daid/marlin_build/ Leaving all selections as default except selecting the Honeywell thermistor for "Third extruder temperature sensor " (this is where I select the heated bed sensor for Ultimaker right?) Getting errors: Marlin - Build from daid/Marlin Build log Marlin/Marlin/stepper.cpp: In function 'void __vector_17()': Marlin/Marlin/stepper.cpp:469:1: error: 'DIOE2_DIR_PIN_RPORT' was not declared in this scope Marlin/Marlin/stepper.cpp:469:1: error: 'DIOE2_DIR_PIN_WPORT' was not declared in this scope Marlin/Marlin/stepper.cpp:469:9: erro
×
×
  • Create New...