Jump to content

tommi

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Hi, I'm using UM3 and Cura 3.3.1 and was happy with it until yesterday. Yesterday morning I switched on my UM3 and followed its wish tu update the firmware. After that I wanted to print a prototype for a sensor holder. I started the UM3 by sending the data from an USB stick and left the room, as I do it in most cases, since I have the UM3. Coming back an hour later looking for the print caused me to stop the printing. The reason for this you can see in the attached photograph. I then tried to explore the problem and made some printing tries with several setting and got always the same. The printer does very small movements while printing the infill and still oozing material as normal. If you look the layer view in CURA, you will no find any of the movements. So my idea was to find the firmware update as guilty. May be I'm wrong but I don't know how to solve this. Please anybody help. UM3_3483-07.curaproject.3mf
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!