Like this?
[profile]
filament_diameter = 3
nozzle_size = 0.4
wall_thickness = 0.8
retraction_enable = True
layer_height = 0.1
solid_layer_thickness = 0.6
fill_density = 20
print_speed = 50
print_temperature = 220
support = Exterior Only
enable_raft = False
filament_density = 1.00
skirt_line_count = 1
skirt_gap = 3.0
retraction_min_travel = 5.0
retraction_speed = 40.0
retraction_amount = 4.5
retraction_extra = 0.0
travel_speed = 150
max_z_speed = 3.0
bottom_layer_speed = 20
cool_min_layer_time = 5
fan_enabled = True
bottom_thickness = 0.3
object_sink = 0.0
enable_skin = False
plugin_config =
model_matrix = 1.6,0.0,0.0,0.0,1.6,0.0,0.0,0.0,1.6
gcode_extension = gcode
alternative_center =
cool_min_feedrate = 10
fan_layer = 1
fan_speed = 100
fan_speed_max = 100
retract_on_jumps_only = True
solid_top = True
force_first_layer_sequence = True
extra_base_wall_thickness = 0.0
infill_type = Line
fill_overlap = 15
sequence = Loops > Perimeter > Infill
hop_on_move = False
joris = False
raft_base_material_amount = 100
raft_interface_material_amount = 100
raft_margin = 5
support_dual_extrusion = False
support_rate = 50
support_distance = 0.5
bridge_speed = 100
[alterations]
start.gcode = ;Sliced {filename} at: {day} {date} {time}
;Basic settings: Layer height: {layer_height} Walls: {wall_thickness} Fill: {fill_density}
;Print time: {print_time}
;Filament used: {filament_amount}m {filament_weight}g
;Filament cost: {filament_cost}
G21 ;metric values
G90 ;absolute positioning
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F{max_z_speed} ;move the platform down 15mm
G92 E0 ;zero the extruded length
G1 F200 E3 ;extrude 3mm of feed stock
G92 E0 ;zero the extruded length again
G1 F{travel_speed}
M117 Printing...
support_end.gcode =
support_start.gcode =
cool_end.gcode =
cool_start.gcode =
replace.csv =
end.gcode = ;End GCode
M104 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.5 E-5 X-20 Y-20 F{travel_speed} ;move Z up a bit and retract filament even more
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
M84 ;steppers off
G90 ;absolute positioning