I went through and checked everything also. Motor screws, pulley set screws, installed belt tensioners, made sure head screws were tight, short belt tension. Calibrated my steps for e. Installed the extruder tension bearing mod.
The only thing left is the linear bearing play.
Here are some photos.
The last two are to illustrate that some prints with the same slicing settings come out perfect.
I seem to have trouble with print that have circles and curves. The curves do not have fill to the edges.
I have to see. I have other prints I will have to dig out that may help.
Mike
forgot to mention in the one photo you can see that I'm able to bend back the outer wall. It did not stick to the inner wall. This only happened on certain out side perimeters. Not all the way around the piece.