tresdemaker

Hi! gr5, thank you for your answer. And for the fixing I have good news, I finally got to fix my Ultimaker. The problem was in a weld, had little tin. I soldered one pin on the motherboard "Heater 1" and now works fine. Thx!

Hello, my Ultimaker has stopped printing, the message appeared yesterday "Error:mind temp" in ulticontroller. I have moved the wires from the plate and no longer get the error, but the temperature does not rise. I have seen where it is written Heater 1 has melted solder ... I thought that if I change the cables and put in place the Heater 2 (what is perfectly welding) could be a solution. What do you think? Is it possible? would have to make changes in the firmware? thank you in advance.