fabbers

I'm having the same problem, and have even printed the improved nozzle clamp as referenced above. I did add a heated bed to the mix which meant I used a firmware compiler that I found on the forum here. The reason I bring it up is that I wonder if there is some mismatch in the parameter of filament feed/ to the actual depositing volume which after maybe 5-10 minutes builds up such force to pop the tube out from the clamp? I even tried to reinforce a volume of the clamp with a piece of paper around the tube and can indeed lift the ultimaker from the tube when I start up. Need help!

Hi, I'm going to try to configure upload myself tomorrow, but I see there is listed. Ultimaker and Ultimaker Experimental. Could someone enlighten me as to which I should choose or what is the difference in the parameters? Thanks in advance.

I'm also getting this issue. Does anyone know how it was solved. We've checked all connections, when we take the TC out of the heater block we don't usually trigger the MINTEMP (but sometimes we do), we also can't get a positive reading trying to hold the TC by hand or touching with a soldering tip. Any help would be appreciated.