UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Created g-codes on a few different models fro my Felix printer. Worked fine on single models however when I printed duplicates it was unacceptable. I used the same setting as the single prints, the duplicates were very "furry" between models and melty. Any suggestions?
Running Cura on non-Ultimaker
in UltiMaker Cura
Posted
Created g-codes on a few different models fro my Felix printer. Worked fine on single models however when I printed duplicates it was unacceptable. I used the same setting as the single prints, the duplicates were very "furry" between models and melty. Any suggestions?