olafson

Hi Illuminarti, It's fixee now. Have it under control because of your advise! Thx Regards, Olaf

Now the foto is visible. It was still on the private mode :-)

This is the surface how it looks after the printer nozzle scratch over the surface.

But I can not see any lifting of the corners. Everything is sticked to the platform very well, also the tape. The problem occurs over the whole surface and not only at the corners but also in the middle. Does you advice stay the same? How can I attach a photo here? I only find an url link

I am not sure if the height of the platform is the issue of course, due to no experience yet :-) But I am hearing the nozzle making a scrathing and gridding sound, also I see that the layer which is printed is feeling very rough and looking sandy. Temp: 210 degrees Filament: PLA 2.89mm Layer hight: 0.1mm I am not in the occasion to make picture/video of it, will post that tomorrow

Hi, I have a new Ultimaker and assembeld it by my self. Everything is working fine. But when I am printing a wide object like a box of 8x4cm, the nozzle is scratching on the layer he just printed. It is happening when the printer is at a height of approx 10mm. Only when I am printing something small like a monopoly house, its working fine and do not scretch. Before each print I run the "bed leveling wizard" and screw each corner to zero. (so it is in contact with the nozzle) I also tried to start with a bed level of 0,1mm lower, but then the filament is not sticking onnthe bed anymore when printng the first layer. Somebody know what the problem is?