Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up

lan

Dormant
  • Content Count

    3
  • Joined

  • Last visited

    Never

Everything posted by lan

  1. Hi, I have been trying to print the squinty head model (http://www.flickr.com/photos/98728747@N03/9263653778/lightbox/). The setting I used were: Layer height : 0.1 Shell thickness : 0.8 Top thickness : 1.2 Fill density : 0 Is there any other setting that I should change? Thanks in advance for your advise guys!
  2. Thanks guy for the suggestions, I will try it this weekend.
  3. Hi guys, I am new to this forum and I have been using Cura with my non-ultimaker 3D printer for the last couple of weeks. I found it is far much better than repetier in terms of ease of use, slicing speed, stability and print quality. There are only two minor problems I faced : 1. How can I extrude/retract filament directly using Cura? Currently I have to use repetier to extract/rectract and then use Cura for printing. 2. The print time showed was not accurate. For example, Cura shows the print time is 8 minutes but in actual it took half an hour to print. Hope you guys can help me with those problem, thanks a lot...
×
×
  • Create New...