Jump to content

ben-in-pa

Dormant
  • Content Count

    1
  • Joined

  • Last visited

    Never

Posts posted by ben-in-pa


  1. I had the "no card" issue yesterday. The front screen showed "card inserted", but the menu indicated "no card".

    As a side note, I had some difficulty during insertion of the 2 GB card, there was a small bit of plastic that was between a couple of the contacts that broke and was sticking up like a hang nail. I trimmed it off and thought all would be well.

    I disassembled the UltiController and found this - Picture (a bent contact pin on the SD card slot). I was able to bend it back into place and it is, once again, working.

    It was not necessary to remove the longer screws with the stand-offs that are holding the board to the wood cover. I removed the sides and the back only.

    It has been mentioned that SDHC cards are not recommended for the Ultimaker UltiController. This may be the official recommendation, but I had been using 16 GB SDHC memry cards without an issue, except for the above (which is unrelated to the type of card).

    Ben

     

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!