Jump to content

mygoal

Dormant
  • Posts

    4
  • Joined

  • Last visited

    Never

Everything posted by mygoal

  1. Thanks a lot illuminarti! I checked everything again, reassembled parts, losen and tightened every screw I could find... and all looks well now!
  2. I just checked everything again... Reassembled parts, losen every screw and tightened it again... And now everything looks doing well... Hope it was the same problem!
  3. I read the post “Lopsided/Skewed Prints” by djproductdesign because I have the same kind of problem. So again I tightened every screw I could find and checked that the short belts aren't rubbing on the frame, just like Illuminarti and gr5 suggested. But without any possitive results. The problem appeared all of a sudden and first look to have been gone but now it's even worse. The firts models where perfect. – For the firsttime it's slightly visable at the Owls but I didn't took a note of that because after that I printed some blocks which where okay. – Than the Mont Saint-Michel became like a dream-print. It looks like it came back to it's original point, which I think is a bit different that djproductdesign had. After this I printed again some blocks (10x10x10mm) and again these looked fine. – So I imported a drawing with some more geometrie but this went terrible wrong. – From that moment everything is printed skewed; the blocks, the Ultimaker-logo-robot... check http://umforum.ultimaker.com/index.php?/gallery/album/152-problems-skewed-prints/ for pictures
  4. Tightened the screws but still lopsided/skewed prints I read the post “Lopsided/Skewed Prints” by djproductdesign because I have the same kind of problem. So again I tightened every screw I could find and checked that the short belts aren't rubbing on the frame, just like Illuminarti and gr5 suggested. But without any possitive results. The problem appeared all of a sudden and first look to have been gone but now it's even worse. The firts models where perfect. – For the firsttime it's slightly visable at the two Owls but I didn't took a note of that because after that I printed some blocks which where okay. – Than the Mont Saint-Michel became like a dream-print. It looks like it came back to it's original point, which I think is a bit different that djproductdesign had. http://umforum.ultimaker.com/index.php?/gallery/image/890-02-mont-saintmichel-s/ After this I printed again some blocks (10x10x10mm) and again these looked fine. – So I imported a drawing with some more geometrie but this went terrible wrong. – From that moment everything is printed skewed; the blocks, the Ultimaker-logo-robot... If anyone has a solution how this can be resolved, please let me know. Thanks! PS I tried to put pictures in this message ... but I think it didn't work out... check http://umforum.ultimaker.com/index.php?/gallery/album/152-problems-skewed-prints/ to see them
×
×
  • Create New...