Jump to content

Dim3nsioneer

Ambassador
  • Posts

    4,297
  • Joined

  • Last visited

  • Days Won

    33

Posts posted by Dim3nsioneer

  1. And there is a solution with the Digital Factory. I would not expect Ultimaker to implement something similar into the firmware itself. The electronics inside the Ultimaker printers have limited capacity, hence the solution with the cloud service.

    If you need a stream, you might have to implement a webcam. The advantage there is that you can chose the angle.

  2. 3 hours ago, gr5 said:

    I think you are just going to have to go with gyroid and drill a hole 😞

     

    Yes to the first part and no to the second part. 😉

     

    3 hours ago, gr5 said:

    by setting "bottom layers" to zero

    You almost had it 😃

     

    Use gyroid infill and set 'Initial Bottom Layers" to zero.

    Now, we can start with the "what if"s... 😆

  3. 16 minutes ago, gr5 said:

    "digital factory reset" or something like that - it resets all network related things and fixes all manner of networking issues

    That is certainly worth trying first. If that doesn't help, a factory reset (reset all printer settings) might be necessary.

    7.0.4 is the current firmware of the 'latest' channel. If you switch to the 'stable' channel, you will get 7.0.3. That change might also be something to consider.

  4. I would replace the board even if one could replace the electronic components since the burned surface might have become conductive and would still be a safety hazard.

    Ultimaker resellers should be able to get you a new board. You find all official resellers at ultimaker.com/resellers.

    As a side note, it really needs quite some force to connect the power plug the other way round.

  5. 1 hour ago, ManAtArms said:

    Leider scheint IGO3D ein Monopol zu haben was ALLE Ersatzteile angeht.

     

    Das ist nicht (mehr) so. Alle offiziellen Händler der DACH Region bestellen direkt bei Ultimaker und können dort Ersatzteile beziehen. Ob das ein Händler effektiv machen will, bleibt natürlich die Entscheidung des Händlers.

    Die sogenannten E-tailers, d.h. grosse Onlineshops sind hingegen aktuell bei iGo3D angeschlossen.

    • Like 1
  6. Wenn man es ganz genau nimmt, dann ist der Druck der Grünling. Den Braunling bekommt man mit BASF Material eigentlich nie zu sehen.

    Vergesst das Selbermachen. Der Debinding-Prozess ist sehr speziell (katalytisch) und erfordert sehr teures Spezialequipment. Es gibt die Servicestelle von Elnik im Schwarzwald. Zugang dazu erhält man über das BASF-Portal (nur EU) oder via Einzeltickets, die bei Ultimaker-Händler mit Metal-Kit im Angebot erhältlich sein sollten.

    • Like 1
×
×
  • Create New...