Dears,
I want to build marlin firmware with makefile, and I have installed Arduino 1.5.2 and the install path is G:/software.
Then I changed makefile as below:
# This defined the board you are compiling for (see Configuration.h for the options)
HARDWARE_MOTHERBOARD ?= 72
# Arduino source install directory, and version number
ARDUINO_INSTALL_DIR ?= G:/software/arduino-1.5.2-windows/arduino-1.5.2
ARDUINO_VERSION ?= 152
# You can optionally set a path to the avr-gcc tools. Requires a trailing slash. (ex: /usr/local/avr-gcc/bin)
AVR_TOOLS_PATH ?= G:/software/arduino-1.5.2-windows/arduino-1.5.2/hardware/tools/avr/bin/
After changed the makefile, from a command prompt, I change into Marlin directory, and then type 'make', it shows below error:
G:\Marlin>make
make: *** No rule to make target `G:/Marlin/applet/wiring.o', neede
d by `G:/Marlin/applet/Marlin.elf'. Stop.
Very appreciated if any help~
PS: Actually, I am not sure about the arduino version :152