Jump to content

ewoud-van-munster

Dormant
  • Posts

    3
  • Joined

  • Last visited

    Never

Everything posted by ewoud-van-munster

  1. Hi Gr5, thanks, yes we will lower the table at the same time (it is the same table) and we are planning to print one layer, slide the table in the x direction, than print the first layer of the empty plave, than lower the table, print the secend layer, move the table etc. we will have to write some Mcodes in the firmware to let the printers communicate, but i have another question, is it possible to generate the gcode in a relative positioning system (gcode G91)?
  2. ohkee, i see, thanks a lott, these are some usefull tips, i will upgrade the firmware, tweek the heatsensor becease i don t have one and don;t try too run that long. i see an explanation is required, With a few other students we are trying to print larger object faster without quality los, we try this to connect 2 ultimkamers and let them print one object. to do this I will use the 5th motor to move a table between two ultimakers, you van take a look at our (unfinished and currently under rivision) weblog at http://kamermaker2013.weblog.tudelft.nl/
  3. Hello everybody, At the moment i'm trying to combine 2 ultimakers in order to print faster and larger. the problem is that this is my first ultimaker project, and although i have some programming experiene, i ran into a problem, i've connected a 5th motor in the 2nd extruder slot on the arduino. the motor works and the driver too, but i can t get my motor spinning. I think i;m using the wrong gcodes, at the moment i have tried these kind of gcodes: M6 T1 ; change to 2nd extruder G1 E1000 ; extrude 1000mm from 2nd extruder G1 B1000 ; extrude 1000mm from 2nd extruder T1 G1 E1000 but no code works, could anybody tell my what the proper code is or what else could be wrong? Greetz, Ewoud
×
×
  • Create New...