HI All,
So I only got the printer on Friday, had a few successful prints so was pretty happy. I was just printing using the quick print (Normal quality) and got OK results, my main issue was with (not sure of the term) but looks like small over prints or excess PLA when moving from one object to another.
So reading through here I decided to enable the expert settings and with reading through a few posts edit some of my settings to have a starting base.
So when I now try and print (using Ultimaker provided blue PLA) it doesn't look like it laying any (or not enough by a long shot) of filament for the base layer. With the same object if I go back to non expert mode and re slice it it prints fine.
Temps are the same between the two and print speed is the same, I know there are plenty of other factors but all I really changed was the 2 settings in retraction to zero and increase the retraction height to 5.5 as was suggested.
Another 2 quick ones for you guys (sorry). I had an SD card error, so I simply plugged my computer in and did a install default firmware which went fine, but due to my first layer prints looking funny I went to re level the bed and now the print head moves over the glass holders at the front, which i guess should not happen!?
Second is the print time between the cura print time and what it says on the UM2 screen are very different, even when I make print speed to 100%? Not that this is a show stopper just confusing.
Thanks for you help in advance..
GBR1