happycamper

Thanks guys. I have the infill set to 30. I played with higher temperatures and it seemed to maybe help a little, but the thing that helped the most was when I turned retraction off. It seems it kept doing retraction and not filling in all those spots...

Thanks! I'm only printing at 30mm/s The prusa i3 I have is not that fast I guess...

Thanks for the help. Good to know where to look. I figured I was going too fast because the temperature is set to 190 for PLA. I'd think thats enough isn't it? I looked at the infill speed and it was set to the same as the regular speed. I set it to 0 anyway. Maybe I have a clog or something? Not sure. Thanks for the tip on what to look for.

I have a prusa i3 from makerfarm. I decided to try cura instead of slic3r. It only took a couple prints and I have switched to cura and haven't used slic3r for a while. Can somebody give me a clue to what my infill is doing here? It seems sparse. Is this due to retraction or something? All my infills do this with cura. It hasn't seemed to be a problem so far, but I think it might in the future be a problem with other models. Thanks! Awesome software!