Jump to content

ct4

Dormant
  • Content Count

    3
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. Not too sure if this is a bug but When I previewed layers in Cura version 12 the image moved off the build plate and displayed in the lower left corner, In version 13 the layer did not move from the center of the build plate and just showed the layers...Great! Now in version 14 it is back in the lower left corner again. Not a problem if I could slide the image over but all I can do is get it to rotate and zoom around center. Am I doing something wrong, and is there a way to slide the image around on the screen. I have attached a couple of screen grabs to show what I mean.Thanks
  2. Thank you that was the problem
  3. I have been trying to use Cura with my Makerbot Rep 2. Everything works well until I try and print the file it generates, It try's to place the print at the right rear of the build plate instead of center.Is there some setting I have not found that will fix this problem?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!