UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am now printing a project , I use Quickprint "Fast low quality print" . The wall and other parts is printing very well. Just that the floor of my print or maybe i should say its top the is printed very thin and in doing so create hole on some conner. I know i can do some setting to take care of it. Well I am posting this is since its a preset on Cura quickprint, so I feel that your team need to do some checking. As the project is still in printing with 7 more hours to go and I need to print another copy. I hope to do some setting to correct the issue. Any advice is appreciate. Below is some image to show the issue. Thank you.
As I cannot disclose the project so this is just to show the size. :mrgreen:
The idea of using a dry box with silica pads or electric cabinet is to absorb the moisture absorbed by the ABS or PLA while the are out in humidity atmosphere when we using it for printing. Using the resealable bag by putting the spool back in and suck out the air, will that remove the moisture retain in the ABS or PLA?
Which version of OSX are you using, I have started using with version 14.01 and now 14.04-RC1, still ok. Fully use of the Cura, no I am not there yet :mrgreen: but the menu issue did not happen to me. :mrgreen:
Did this at
210 / 60. 20mm/s No retraction.
From the above print, I feel that its too hot. So i set 195 / 40 cause I feel that everything is printing too near to the bed.
This round I print 2.
I think its not bad but what are causing those?
You read my mind. :mrgreen: And the Basic and Advance setting also confuse me too. You set "Print speed (mm/s)" on Basic and on Advanced only " Travel speed (mm/s)" . If its an Advanced setting, we should be able to set both there. :mrgreen: