kegs
-
Posts
10 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by kegs
-
-
My Ultimaker v2 was shipped with a bad display a while back and I finally got around to replacing it.
I'm stuck with how the scroll wheel assembly is removed from the enclosure. It seems to have a lip
around the edge that wont let it pass through the hole. Any ideas on how it comes apart?
-
Or the spec of the capacitor-
It says 100 VFP. 3B0 - not sue if the last zero is a "o" or "zero"
I was looking here-
-
Has anyone had blown cap on the control board and know what would be the root cause? I recently moved into a new office and was running a print, I saw a flash and the machine went down, no response, lights or sounds. I opened it up and it looks like a small capacitor was blown right where the power comes in.
-
Is the buildplate within paper thickness to the printhead?
-
I will measure later- I would guess that they are that long, they seem to catch 4 turns or so..
-
They need to put some longer screws in there, these just barely catch...
-
OK- Found exp1 and it was totally off--went through start up and then right hand
drive belt started flopping around and the screws holding the drive motor fell out of the back.
I think they have some major quality control issues. Any advice on re-attacting motors?
-
Nothing happens when you press or turn the control button. I see the control cover panel, but lock nuts won't loosen up with that small of a hex wrench without stripping, I guess it is not intended as a service item- I did notice that that cover has a big dent like someone picked it up to package it and knocked the tab out of the outer panel pocket, maybe crushed something on the inside.. I guess I will have to get those little screws out of there somehow..
-
Just got my UM2 after 10 1/2 weeks, plugged it in and the control panel does not
go on....any ideas? Fan and interior LEDs go on..highly frustrating experience so far.
Scroll Wheel/Push button.
in Improve your 3D prints
Posted
Thanks for pointing out the super secret access hole! It takes a lot of pressing and rotating the button little by little, but it worked!