UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The builtplate of my 1 week old Ultimaker2 won't raise properly. It only raises about 8 cm, then stops.
Everything worked just fine yesterday.
Today I wanted to fine tune the builtplate, and started the procedure. When the builtplate was raised to begin with, it stopped short by about 2 cm from the nozzle (when it asked me to adjust it to 1 mm from the nozzle, which evidently wasn't possible).
After that I raised the builtplate by going to the Advanced settings. It then stopped even further down. And subsequent attempts only made it worse. Now it will only raise about 8 cm.
I uploaded new default firmware from within Cura. I turned the machine off and on. Nothing helped.
I tried to print stuff, but as it started to print mid air, I aborted the printing.
Builtplate wont raise properly
in UltiMaker 3D printers
Posted
TO MODERATOR:
I FOUND THE SOLUTION: PLEASE DELETE THIS MESSAGE!
The builtplate of my 1 week old Ultimaker2 won't raise properly. It only raises about 8 cm, then stops.
Everything worked just fine yesterday.
Today I wanted to fine tune the builtplate, and started the procedure. When the builtplate was raised to begin with, it stopped short by about 2 cm from the nozzle (when it asked me to adjust it to 1 mm from the nozzle, which evidently wasn't possible).
After that I raised the builtplate by going to the Advanced settings. It then stopped even further down. And subsequent attempts only made it worse. Now it will only raise about 8 cm.
I uploaded new default firmware from within Cura. I turned the machine off and on. Nothing helped.
I tried to print stuff, but as it started to print mid air, I aborted the printing.
What is wrong? What to do?