Thanks,
I was able to improve my printings. I uploaded new pictures in my gallery.
As you can see, the disk is better now. First I just made it slower and enabled the cool head lift on, but it was not satisfying, the points were too messy. Then I disabled the cool head lift option and set the "minimum layer time" to 9 seconds. It looked better but there was still too much material on the points. Finally I used the plugin tweak At Z 3.1.1.
Here are my important settings for the best disk I have printed so far,
Minimal Layer time: 9 sec
Cool head lift: No
Tweak At Z 3.1.1
- Layer No: 14
- New Extruder 1 Temperature: 185°C
The ring looks better aswell, but the outside looks unclean, now. I tried it with and without cool head lift. The pictures which are uploaded are the best results so far. These were printed with the cool head lift option.
Also I had to clean up my print afterwards like illuminarti predicted it.
The settings for the rings are
Print speed: 30 mm/s
Cool head lift: on
Minimum layer time: 8 sec
Is there anything I could do to improve the rings?
I slowed it down to 30 mm/s but I did not try to print it lower than that. Is that the only option to me to get a better result or are there other parameters I could work with?