Hi everyone, some really nice prints on here.
I'm new to independent 3D printing and thought I would share one of my latest prints.
I had a few problems with the Ultimaker 2, like the fans and screws missing from the print rods. Hopefully its ok now.
This print is of Slithe from Thundercats. it was printed in Colorfabb Greenish Beige at a height of 14 cm and taking 14 hours. The settings in Cura were 0.1mm layer height, 50mm print speed, 0% fill density and Cura support.
All three pieces ( head, stand & buckle) were printed at the same time so I had quite a bit of stringing and a few tiny holes.
It was first modelled in 123D Creature and then improved in Zbrush.