Hi Guys,
I am printing Iphone 5 case with:
black Flex from Ultimaker.
Cura:
layer height: 0.2 mm
shell thicknes: 0.9
retraction: on
bottom/top: 0.6 mm
fill: 100%
print speed: 20mm
adhesion type: brim
After brim is printed, it is cover by bleu tape, just for sure in the rornes. I am using this trick with Makerbot 2 which has no heated build plate, and on Makerbot it is solving warping...
In advanced settings all speeds are: 20 mm/s
In expert settings, fan from 0.5 z height is 100 %
Ultimaker settings:
without blue tape, only thin layer of glue stick..
Speed 50 % after a few layers I went to 100 %, but base of print is perfectly connected.
build plate temp: 60 C
temperature 235 C
All Works fine, only long print time is reached. But I think, when I was ever printing with Flex mat, on Makerbot I am (newbie with Ultimaker), this material takes always long time to reach good results. So dont be frustrated by this..
photos:
http://www.pinterest.com/pin/485614772292882678/
http://www.pinterest.com/pin/485614772292882674/