My original ultimaker worked fine until i updated the version of Cura. Long story, but I had to replace the stepper drivers (that's a long story too).
Here is where i am now:
Running:
Windows 7 home premium
Cura 14.03
I have replaced the original stepper drivers with 4
Pololu StepStick drivers with Pot set to 3.05 ohms
And have set the pot for 3.017 ohms.
when i plug the USB cable in & turn on the power, the LED6 and LED7 are brightly lite. (i considered that a good sign since before 6 would dim).
I have the machine settings to 9600 baud and it finds the Ardunio with the motherboard disconnected AND connected.
Here is the problem: When i go to run the Cura first time wizard and update the firmware, it just sits there trying to connect and never does. No error msgs, no sign anything is wrong, just doesn't connect. SInce i can see the Ardunio on com24, i assume the port and cable are good.
Any ideas what i can test next or what i should set the pots at (if that is even the problem).
Thanks for you help, I hope i posted this to the correct board. I searched and did not see similar issues.