UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hi all , I have a problem with printing. I post here 2 videos , so u can see it.
In few words, when I try to print first 5 layers put well then , extruders drive motor start knocking and it can't print.
Sorry for my bad English
Thank you for help, i made it work. So i had to invert 2 axis X and Y in marlin builder i have to do 2 ticks on Y and Z axis. So now everything works fine! Thank you very much! I appreciate your help!
Thank you , now x and y axis work fine. But when i try to print smth, Z axis going down for home, as i know it should go up, i will put here my compilation , so maybe u can help me.
http://gfile.ru/a6AR0
250000 baudrate, so maybe someone can upload here fully working marlin firmware with X and Y axis inverted?
axises dont work for me.
extruder stucked in the corner, and i cant control it.
Hello everyone, i'm newbie in 3d printing. So i bought used ultimaker with inverted X, Y axises. Trying to compile marlin firmware with Ginge's builder, then upload firmware with cura 13.12 and it's gone. I cant control x and y axises and when connect to replicatorg there is an error
So i want you to help me with this problem. Thank you, sorry for my bad english.