simchess

Hello, Has any one experience lines on the prints as per the attached. I have printed some 800 + chess pieces plus a few smaller projects and now starting to get these lines. nozzle is clean and the belts have been tensioned using a tensioner downloaded from you magine.... MArk

Hello can any on e suggest why I would be getting lines on my prints.....I would love to up load a picture but I always seem to have trouble doing so on this site both in ultimaker and you magine????

many thanks for the reply, found out it is a setting in the machine .....machine settings.....gantry height.... mark

many thanks sir I will give it a go......

hello , how can you alter the height at which cura decided that you cant print multiple object one at a time. Mark.

Hello, I am Currently printing out many chess pieces and would like to know how to disable or override cura in deciding the height with which it will allow you to print multiple objects higher than the bottom rails. Yes I know the has a risk as I have already had a problem. my standard size castles (bishops) will not fit under the rails once printed however the cura software will still allow this to print in multiples. the trick I found was to position them in the correct orientations and they will not clash. you can only print 4 at a time other wise you will still clash. I need to be able t

Hello I was wondering the very same thing. I am printing out many chess pieces, I can print 10 pawns no problem one at a time. two castles and a prince and princess no problem.......this is the confusing bit. when I first printed the 2 x castles and prince and princess when, I came back to the completed print one of the castles had been knocked over. The castles were to tall to clear the gantry....I have the latest cura update and still the same thing happens. this is not a problem as I can place the pieces so that the gantry does not hit the castles if the spacing is set correct and the sequ