aelzayn
-
Posts
8 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by aelzayn
-
-
but no way to do it on glass?
-
thanks
-
Hey guys,
I started to try to print with nylon 618 but I noticed all my prints were not sticking. I tried a variety of temps. I also tried using glue and blue tape and nothing works. How can I fix this?
-
1
-
-
Fixed!
-
Thanks. One of the wires near the printhead came disconnected. Fixed!
-
Hi guys,
I noticed my two side fans weren't working during prints even though their speed was set to 100%. In addition, I opened up the bottom and noticed that there was a wire that wasn't plugged in to anything, but I cannot find where it goes as it doesn't fit in the only two open spots. Please help.
i attached a picture.
-
Hey guys,
Ive noticed that during my prints, at random times, the printer will just stop extruding and continue to go through the motions, but nothing comes out. Im using an ultimaker 2 with the standard PLA settings using the blue PLA provided by ultimaker. I really want to fix this, as it is making printing impossible. At the beginning of each print, some will come out and it will work fine, but them just suddenly stops. It also extrudes properly when extracting material then putting new material in and letting some come out. Please help.
-Andrew
Stops Extruding Midway - Solved
in Coffee corner
Posted
In the back of the printer, where the filament is loaded, I played around with the placement of the piece of metal that spins to load the filament. It seems that the filament was sliding off of that and stopped loading.