Jump to content

moegibike

Dormant
  • Content Count

    1
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. question , i,m using a simple trick to go on after fail with printing after ouhrs. 8 out of 10 time,s it go,s quit good ,and no los of my ouhrs printing . got a hal sensor part for the filament , when stuck ore not delivering filament after a adjustible time , it take with the webcam a pic from my cura from the pc screen and stop the 3d printer with printing . im reading the height that it has printed , into cura i save the g- code and open it with words and go to the height point where it whas left . i copy it and make a new g-code prog . then i start the printer again , you need a 100% solid end stop , no wakkeling ore half loose micro switch , this way you get the starting point real good again . starting the printer with only the first layer to print with a 25% speed to flatten nice the top from the last layer, it smooth out more the printing and getting a little thicknis here and there, but always better then lost a 20 ouhrs print . my question then now , is there a simpler way to go on when print is failing ? is it a option for cura to ad a plugin for...... , start from line nr ore layer nr ....... ????
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!