Hello guys,
This is my first post here and unfortunately it's with an issue.
It started last night during a 10 hour print: https://www.dropbox.com/s/sxryglbjkiq8eot/IMG_1632%20copy.jpg
As you can see, there are a few distorted layers and the piece broke in half when I removed it.
I re-calibrated the bed, tried a new print (http://www.thingiverse.com/thing:265525/#files) and again the same problem as you can see below:
https://www.dropbox.com/s/49s70ykop6al257/IMG_1630%20copy.jpg
https://www.dropbox.com/s/yej0pg6h298j8rw/IMG_1631%20copy.jpg
print speed: 50mm/s
layer height: 0.1 mm
fill: 15%
Any thoughts on this?
Thank you