Ok, I've been browsing and searching through the forum for a while now.
First I assumed it was business as usual that the cooling fan on our preassembled ultimaker original was always on at full speed.
After reading that large prints were best left uncooled at first to avoid warping I tried to alter the fanspeed through the tune menu whilst printing.
The Cura setting had always been set to be slower at first, building up to 100% at 0.5 mm height.
No luck adjusting it manually.
This got me quite worried.
Just now I tried some prints where I've told Cura, the new version 14.07, to slow the fan down at first.
Still, the fan is at 100 percent (or so I think) all the time.
From the moment I turn the entire machine on, to the moment I start printing.
Am I overlooking something?
For details, the Ultimaker came preassembled about a month or two ago, has an Ulticontroller, works fine otherwise... I think.
I always use the SD to control the Ultimaker but have updated the firmware the first time I connected to the Ultimaker with a laptop.
I'm worried something is wrong as is, what should I do?
Thanks so much.
Greets, Lara D