Jump to content

cookingissues

Dormant
  • Content Count

    1
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. Thanks. I hope this is the right place to ask. I have an Ultimaker 2. I'd like to print polycarbonate. From what I gather, 255 C is the rock bottom minimum you can print PC at without jamming but 265-270 is much better, and that to achieve reasonable speeds (above 30 mm/s) requires closer to 270. Is there a workaround to the firmware limit of 260C, and if so, will the extra 10 degrees damage the machine? Can the firmware be altered in the UM2 (it has been a while since I've done arduino programming but if someone points me in the right direction I can prolly handle it).
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!