fullscaleprinting

I would love to have some good calibration software! So here is my idea/wish of how it could work. For speed: I'm not a programmer, but i would like to see a program or script which finds all the limits and optimums of the printer and fixes this in the speed/calibration settings: A script or program that slowly accelerates the extrusion speed, and then you can say: this is the maximum. (where it starts skipping on the hobbet bolt. With a logical reasoning behind it should be possible to say : at 70? % of this speed the chanche of skipping is 0.00? % this limit should be fixed in the software so it will never exceed this limit. The same for acceleration: slowly increasing acceleration while printing for examle a zigzag pattern. Then say: corners are good over here (related to oozing) or untill the steppers start to skipp a step. Then you just say: maximum speed and it stays within its limits. With this: the computer could also calculate it for multiple layerthicknesses and find its optimum balance between speed and layerthicknes (balance between axis speed and extrusion speed) For retraction: a square full of start/stop points: y axis increases retraction length step by step, x axis increases retraction speed step by step. Then there's an optimum in the square which you can tell to the computer. Like a calibration paper from an inkjet printer.